Различия

Показаны различия между двумя версиями страницы.

--- en:manual:dmxrgbdecoder:decoder_dmx [2017/03/31 20:49] – Leo
+++ en:manual:dmxrgbdecoder:decoder_dmx [Дата неизвестна] (текущий) – внешнее изменение (Дата неизвестна) 127.0.0.1
@@ Строка 49: / Строка 49: @@
 Connect several single-color models to one decoder, with their positive output
 Connect to the V+ terminal on the decoder.
+===== Connecting the DMX-512 signal =====
+The DMX512 signal uses a **CAT-5 cable** or a three-wire braided cable, while the DMX-
+The signal has a positive (+) and negative (-) poles. When soldering the DMX-
+Should be observed so that there is no short circuit between the positive
+(+) And negative (-) poles, and then connect the cable
+Corresponding to the input interface of the DMX24506.
+<note important>Connect the signal output to the end of the entire connection (you need to install DIP-Switches DMX24506 to the off state).</note>
+===== Where to buy =====
+[[http://ali.pub/42pwn|Buy on Аliexpress - ~15$ - 25$.
+]]