Различия

Показаны различия между двумя версиями страницы.

--- en:manual:dmxrgbdecoder:decoder_dmx [2017/03/31 20:45] – Leo
+++ en:manual:dmxrgbdecoder:decoder_dmx [Дата неизвестна] (текущий) – внешнее изменение (Дата неизвестна) 127.0.0.1
@@ Строка 26: / Строка 26: @@
 ^ Output power | 3 Amperes per channel ((Each channel gives out 3 amps)) |
 ^ Effects | Inclusion, intensity, mixing |
-^ [[: Wiki: dmx_512 | DMX]] | Set the address of the DIP switches. | | |
+^ DMX | Set the address of the DIP switches. | | |
 ^ Working voltage | 12-24V |
 ^ Operating temperature range: | 0 ~ 50 ° C. | | |
@@ Строка 33: / Строка 33: @@
 ^ Weight: | 110g. | | |
 ^ Optional | Power can be increased by amplifiers |
+===== Interface Description =====
+Input DMX IN and output DMX OUT interfaces can be interchangeable.
+Address setting interface
+For usage procedures, refer to the "//**DMX address code table**//".
+The table of addresses of codes of series **DMX**.
+**12-24VDC** input, power supply for decoder and lamps.
+==== Driver Output Interface ====
+The common anode, V + and R, G, B interface can control the RGB module or single-color module. WHO-
+The ability to control the output current in relation to the actual load.
+Notes: Connect the positive lead and RGB wire of the common anode of the RGB module.
+To the output interface of the decoder.
+Connect the positive terminal of the monochrome module to the V+ on the decoder, and the negative output to the
+One of the RGB module outputs according to the color of the LED.
+Connect several single-color models to one decoder, with their positive output
+Connect to the V+ terminal on the decoder.
+===== Connecting the DMX-512 signal =====
+The DMX512 signal uses a **CAT-5 cable** or a three-wire braided cable, while the DMX-
+The signal has a positive (+) and negative (-) poles. When soldering the DMX-
+Should be observed so that there is no short circuit between the positive
+(+) And negative (-) poles, and then connect the cable
+Corresponding to the input interface of the DMX24506.
+<note important>Connect the signal output to the end of the entire connection (you need to install DIP-Switches DMX24506 to the off state).</note>
+===== Where to buy =====
+[[http://ali.pub/42pwn|Buy on Аliexpress - ~15$ - 25$.
+]]